ABBREVIATIONS USED IN THIS MANUAL

AX-138
AT2869
AT2867
AT2865
AT8302
SST
AUTOMATIC TRANSAXLE (A240L, A241E, A243L) - Installation of Component Parts
SST
(b) Install the spring, piston and cover into the bore.
(c) Using SST, install the snap ring while pressing
the cover.
SST 09350-31014 (09351-32050)
(d) Check that the front end of the piston rod contacts
the center of the second brake band depression.
69. MEASURE PISTON STROKE OF SECOND COAST
BRAKE
(a) Apply a small amount of paint to the piston rod at
the point it meets the case as shown in the illustration.
(b) Using SST, measure the piston stroke applying
and releasing the compressed air (392 - 785 kPa,
4 - 8 kg/cm 2 , 57 - 114 psi) as shown.
SST 09240-00020
Piston stroke: 1.5 - 3.0 mm (0.059 - 0.118 in.)
If it is still more than standard value, replace the brake
band with a new one.
70. INSTAL ACCUMULATOR PISTONS AND SPRINGS
(a) Coat the new O-rings with ATF, and install them
to the pistons.