ABBREVIATIONS USED IN THIS MANUAL

AX-220
AT2969
AT0635
AT2970
AT0349
AT0350
AUTOMATIC TRANSAXLE (A241H) - Installation of Component Parts
Pin
(c) Coat the races and bearing with petroleum jelly and
install them onto the tip of ring gear flange as shown.
Bearing and races mm (in.)
Outer diameter Inner diameter
Front Race 37.9 (1.492) 22.0 (0.866)
Bearing 36.1 (1.421) 22.2 (0.874)
Rear Race 35.7 (1.406) 23.0 (0.906)
61. INSTALL SECOND COAST BRAKE BAND
(a) Place the band into the case.
(b) Install the pin through the oil pump mounting bolt
hole.
62. INSTALL FORWARD CLUTCH AND DIRECT CLUTCH
(a) Coat the race and bearing with petroleum jelly,
and install them onto the forward clutch drum.
Bearing and race
mm (in.)
Outer diameter Inner diameter
Bearing 42.0 (1.654) 28.9 (1.138)
Race 42.0 (1.654) 27.1 (1.067)
(b) Coat the clutch drum thrust washer with petroleum
jelly, and install it onto the direct clutch drum
with the oil groove facing upward.
(c) Using a screwdriver, align the flukes of discs in
the direct clutch.