ABBREVIATIONS USED IN THIS MANUAL

AT0589
AT0590
AT2938
AT0588
AT2939
SST
SST
SST
Fulcrum Length
AUTOMATIC TRANSAXLE - Component Parts (Counter Shaft)
SST
(d) Temporarily install the new lock nut, and using SST,
tighten the lock nut until the counter shaft starting
torque is in specification.
SST 09350-32014 (09361-32170)
Torque (Reference): 117 - 216 N-m
(A241E, A243L) (1,800 - 2,200 kgf-cm,
130 - 159 ft-lbf)
Torque (Reference): 157 - 193 N-m
(A240L, A241H) (1,610 - 1,970 kgf-cm,
116 - 142 ft-lbf)
HINT: Use a torque wrench with a fulcrum length of 42 cm
(16.54 in.).
(e) Using soft jaws, , hold the drive pinion in a vise.
(f) Using SST and spring tension gauge, measure the
starting torque of the counter shaft.
SST 09350-32014 (09351-32170)
Starting torque: with tension gauge
12 - 20 N
(1.2 - 2.0 kg, 2.6 - 4.4 lb)
with torque gauge
(hexagon nut side)
New bearing
0.6 - 1.0 N-m
(6 - 10 kgf-cm, 5.2 - 8.7 in.-bf)
Reused bearing
0.3 - 0.5 Nrrn
(3 - 5 kgf-cm, 2.6 - 4.3 in.-lbf)
If the starting torque is exceeded, replace the spacer and
retorque.
HINT: Before measuring the starting torque, sung down
the bearing by turning the counter shaft.
(g) Using a punch and hammer, stake the lock nut.
(h) Remove the SST from the counter driven gear.
SST 09350-32014 (09351-32032)
(i) Using SST, remove the counter driven gear.
SST 09350-32014 (09351-32061)
AX-81