ABBREVIATIONS USED IN THIS MANUAL

AX-84
AT3112
AT2944
AT2945
AT5695
AT2947
-
AUTOMATIC TRANSAXLE Component Parts (Underdrive Clutch
and One-Way Clutch No. 3)
SST
3. REMOVE FLANGE, DISCS AND PLATES
Remove the flange, discs and plates from the clutch
drum.
4. REMOVE RETURN SPRING AND SPRING PLATE
(a) Using SST and press, compress the return spring
retainer.
SST 09350-32014 (09351-32070)
(b) Using snap ring pliers, remove the snap ring.
(c) Remove SST.
(d) Remove the return spring and spring plate.
5. REMOVE UNDERDRIVE CLUTCH PISTON
(a) Install the underdrive clutch to the transaxle case.
HINT: Before installing the clutch, install the oil seal
rings to the transaxle case.
(b) Apply compressed air into the oil passage of the
case, and remove the piston from the clutch
drum.
(c) If the piston does not pop out with compressed
air, use needle-nose pliers to remove it.
6. REMOVE O-RINGS FROM PISTON
Using a screwdriver, remove the two O-rings from the
underdrive clutch piston.