ABBREVIATIONS USED IN THIS MANUAL

AX-222
AT8076
AT8048
AT2766
AT2972
AT0637
AUTOMATIC TRANSAXLE (A241H) - Installation of Component Parts
(c) Apply sealant to the bolt threads.
Sealant: Part No. 08833 - 00080, Adhesive 1344,
THREE BOND 1344. LOCTITE 242 or
equivalent
(d) Install and tighten the bolts.
Torque: 29 N-m (300 kgf-cm, 22 ft-lbf)
HINT: Each bolt length (mm) is indicated in the illustration.
65. INSTALL OIL SEAL RINGS
66. INSTALL OIL PUMP INTO CASE
(a) Coat the race with petroleum jelly and install it
onto the stator shaft.
Race: Outer diameter 43.0 mm (1.693 in.)
Inner diameter 30.5 mm (1.201 in.)
(b) Coat the O-ring with ATF, and install it to pump
body.
(c) Place the oil pump through the input shaft, and
align the bolt holes of the pump body with the
transmission case.
(d) Hold the input shaft, and lightly press the oil pump
body to slide the oil seal rings on the stator shaft
through the direct clutch drum.
NOTICE: Do not push on the oil pump strongly, or the
oil seal ring will stick to the direct clutch drum.
(e) Install and tighten the six bolts.
Torque: 25 N-m (250 kgf-cm, 18 ft-lbf)