ABBREVIATIONS USED IN THIS MANUAL

AT8047
AT3345
AT2870
AT2869
AT2867
O-Ring
SST
AUTOMATIC TRANSAXLE (A241H) - Installation of Component Parts
67. MEASURE THRUST PLAY OF INPUT SHAFT
Measure the thrust play in axial direction.
Thrust play: 0.3 - 0.9 mm (0.012 - 0.035 in.)
If the play is not as specified, select and replace the
race for the end of the stator shaft.
HINT: There are two different thickness of races.
If necessary, select one of them.
Race thickness: 0.8 mm (0.031 in.)
1.4 mm (0.055 in.)
68. CHECK INPUT SHAFT ROTATION
Make sure that the input shaft rotates smoothly.
69. INSTALL SECOND COAST BRAKE PISTON
(a) Install the two new O-rings to the cover.
HINT: Coat the O-rings with ATF before installing.
AX-223
(b) Install the spring, piston and cover into the bore.
(c) Using SST, install the snap ring while pressing
the cover.
SST 09350-32014 (09351-32050)
(d) Check that the front end of the piston rod contacts
the center of the second brake band depression.