ABBREVIATIONS USED IN THIS MANUAL

AX-136
AT0525
AT8484
AT5711
AT2766
AT2972
AUTOMATIC TRANSAXLE (A240L, A241E, A243L) - Installation of Component Parts
Seal
Packing
Sealant
62. INSTALL DIFFERENTIAL
63. INSTALL TRANSAXLE HOUSING
(a) Remove any packing material and be careful not to
get oil on the contacting surfaces of the transaxle
housing or transmission case.
(b) Apply seal packing to the transaxle housing as
shown.
Seal packing: Part No. 08833 - 00090, THREE BOND
1131, LOCTITE 518 or equivalent.
(c) Apply sealant to the bolt threads.
Sealant: Part No. 08833 - 00080, Adhesive 1344,
THREE BOND 1344, LOCTITE 242 or equivalent
(d) Install and tighten the bolts.
Torque: 29 N-m (300 kgf-cm, 22 ft-lbf)
HINT: Each bolt length (mm) is indicated in the illustration.
64. CHECK PRELOAD OF DIFFERENTIAL SIDE BEARING
(See page AX-1 12)
65. INSTALL OIL PUMP INTO CASE
(a) Coat the race with petroleum jelly and install it
onto the stator shaft.
Race: Outer diameter 43.0 mm (1.693 in.)
Inner diameter 30.5 mm (1.201 in.)
(b) Coat the new O-ring with ATF, and install it to
pump body.