ABBREVIATIONS USED IN THIS MANUAL

TR-22
AT7794
AT7788
AT7795
AT7787
-
TRANSFER (A241H) Component Parts
(Ring Gear Mounting Case and Center Differential Case)
(c) Using a dial indicator, measure the backlash of one
pinion gear while holding the side gear toward the
case.
Standard backlash: 0.06 - 0.22 mm
(0.0024 - 0.0087 in.)
HINT: Do not mount the surface of center differential case
which contacts with bushing in a vise.
Referring to the table bellow, select the thrust washer
which will ensure that the backlash is within specification.
Try to select a washer of the same size.
Mark Thickness mm (in.) Mark Thickness mm (in.)
A
B
C
D
E
1.00 (0.0394)
1.05 (0.0413)
1.10 (0.0433)
1.15 (0.0453)
1.20 (0.0472)
F
G
H
J
1.25 (0.0492)
1.30 (0.0512)
1.35 (0.0531)
1.40 (0.0551)
(d) Using snap ring pliers, install the shaft snap ring.
5. CHECK AND ADJUST CENTER DIFFERENTIAL
SIDE GEAR THRUST CLEARANCE.
(a) Install differential side right gear.
HINT: Do not install the conical spring washer.
(b) Install center differential case.