Emulator Composite.book - Creative

Modulation Destinations
6 - Voice Processing
Modulation Cords
Destination Description
Key Sustain Holds the envelope generators at the sustain point as long as this value is above zero.
Fine Pitch Fine pitch modulation with a maximum range of 1 semitone.
Pitch Full range pitch modulation.
Glide Controls the portamento (glide) time.
Chorus Amount Controls the amount of voice chorus (doubling).
Chorus Position ITD Controls the Inter-aural Time Delay of voice chorus. See page 116.
Sample Start Controls the sample start offset point. See page 117.
Sample Loop Controls the sample loop length. See page 147.
Sample Retrigger (+) A positive-going, zero-crossing value retriggers the sample from the sample start.
Note: A sample must be looped in order to retrigger properly. For unlooped sounds,
create a silent loop at the end of the sample.
Sample Retrigger (-) A negative-going, zero-crossing value retriggers the sample from the sample start.
Loop Select
(Continuous)
Loop Select
(Jump)
Loop selection that plays through to the next selected loop. Only backward jumping is
allowed. See page 197.
Loop selection that jumps to the selected loop at the end of the currently playing loop.
Forward and backward jumping is allowed. See page 199.
Filter Frequency Controls the frequency (or morph) of the filter.
Realtime Resonance Realtime control of filter resonance (Q, gain, body size).
‘Filter Resonance Filter resonance control which is set at note-on time only.
Amp Volume Controls the volume of the voice.
Amp Pan Controls the left/right positioning of the voice.
Amp Crossfade Controls the RT crossfade of voices so programmed. See page 92.
Send Main Controls the level of the voice sent to the Preset FX and the Main Output. See page 210.
Send Aux 1-3 Controls the level of the voice sent to the Aux Send 1, 2 or 3 FX processors. See page 210.
Wet/Dry Mix Controls the Wet/Dry mix sent to the Preset FX. See page 210.
Amp Envelope Rates Positive values decrease the rates of all amp envelope stages.
Amp Env. Attack Positive values decrease the attack rate of the amp envelope.
Amp Env. Decay Positive values decrease the decay rate of the amp envelope.
Amp Env. Release Positive values decrease the release rate of the amp envelope.
Filter Envelope Rates Positive values decrease the rates of all filter envelope stages.
Filt Env Atk, Dcy, Rel Same as for Amplifier. See above.
Filter Env. Trigger A positive-going, zero-crossing value retriggers the envelope.
Aux. Envelope Rates Positive values decrease the rates of all Aux. envelope stages.
Aux Env Atk, Dcy, Rel Same as for Amplifier Envelope parameters. See above.
Aux Env. Trigger A positive-going, zero-crossing value retriggers the envelope.
LFO Rate (1 & 2) Positive values increase the LFO rate.
LFO Trigger (1 & 2) A negative-going, zero-crossing value resets the LFO to zero.
E-MU Systems 145