Emulator Composite.book - Creative

9 - Effects
Proteus X Composer FX Template
Proteus X Composer FX Template
This is the effects architecture we have chosen to use for the Proteus X Composer bank.
We recommend that you use this scheme as a model for your own presets unless you
have special requirements. Preset effects and global effects can be used simultaneously
and you can use PatchMix DSP hardware effects by simply changing the Aux Output
routing.
The main effects are located in the Multisetup so that they can be shared by all presets.
This is the standard sidechain effects routing scheme found on all mixing boards.
Aux 1 = Reverb and Aux 2 = BPM Delay. MIDI controller K controls Reverb amount
and MIDI controller L controls Delay amount through the Preset PatchCords.
The diagram below shows the Proteus X Composer routing scheme.
Voices
Key Points
Wet/Dry
100%
wet
dry
Main
Aux 1
Aux 2
Aux 3
VOICE
Bypass
FX A
Off
Off
Off
Off
PRESET
Bypass
FX B
Post FX
Sends
Voice
Aux 1, 2, 3 are turned fully down and are not used.
The Main Output is turned up full.
The Wet/Dry Mix is turned to full wet.
Preset
No effects are selected for Preset FXA/FXB. (To add a preset effect, just select one!)
The Main Output is turned up full.
Aux 1 and Aux 2 are initially turned down, but they are controlled by Preset Patch-
Cords connected to MIDI controllers K & L.
Aux 3 is turned down and is not used.
Multisetup
Aux 1 is routed to Reverb.
Aux 2 is routed to BPM Delay.
Important: All the Aux Outputs are set to EX Main (ASIO 1/2) and so they are
mixed together before being sent to the Host computer.
L
Main
Aux 1
Aux 2
Aux 3
K
Off
MIDI
Controllers
(Preset Cords)
On/Off
216 Emulator X2 Operation Manual
Reverb
BPM
Delay
Not
Used
Aux 1
Aux 2
Aux 3
MULTI
Aux Outputs
EX Main
EX Main
EX Main
EX Main