ClearPath OS 2200 Series Release 13.2 Software Planning and ...

Installation
and Support
Name
Installing from Fast-Load Tapes
• Use the SOLAR full-screen interface to register and install specific products and
modes from each registered package tape. Start SILAS and CPComm to activate
a demand terminal.
17. Install the following set of products.
Level
Logical
Tape
Name
Default
Installation
Mode
CKRS 7R8A CP05 COMMON
BANK
FLEX 4R3 CP05 NOAUTO
Notes
TUTIL 1R1B CP05 A If you currently have SAUTILITIES installed and you
want to install TUTIL, you must remove
SAUTILITIES using the PRODRV utility, or install
TUTIL in mode TEST. For more TUTIL information,
refer to “Tape Labeling Utility for ClearPath
OS 2200 (TUTIL)” in Section 5.
UFTN 11R1B CP08 A
UCOB 12R1F CP08 A
ACOB 7R3K CP09 D
FTN 11R2X CP09 AFCB
Installation
and Support
Name
18. Install the following set of products. Before you install these products, the
associated background runs should be terminated. After successful installation and
adjustments, the associated background runs can be restarted.
Note: The installation of tapes CP10 and CP11 might report PRODLD warnings.
This occurs due to the relation between IPF and DDP-FJT and IPF and TAS. A
COMUS CONFIG of IPF is required. See the IPF 1100 Administration Guide.
Level
Logical
Tape
Name
Default
Installation
Mode
DDP-FJT 5R5I CP10 A
cpFTP 3R5A CP11 A
Notes
TAS 6R2I CP11 B TAS may require a post-installation procedure
before it functions correctly. See the TCP/IP
Application Services (TAS) Implementation and
Administration Guide.
DPS 6R5A CP11 A If you already installed the CP-OE2 tape, you do not
need to reinstall DPS.
19. If you have not already installed MCB, install MCB from the CP-TRN tape into
APPL3.
7831 0349–043 7–13