ClearPath OS 2200 Series Release 13.2 Software Planning and ...

Initializing an Existing System (I-Boot)
Note: This installation sequence uses the logical package name. See C.1 for more
information.
The recommended steps are as follows:
1. For metering based systems, prior to performing the I-Boot, ensure all existing COD
Log entries have been harvested from the OS 2200 system by URU-OS2200. COD
Log entries are created every minute. Stop the system within a minute after a
harvest completes. Harvests occur every 15 minutes or can be forced by stopping
and then starting the URU Windows Service. A harvest is performed immediately
after the URU-OS2200 Service is started.
2. Boot the Exec using the supplied boot tape. Set jump keys 4, 7, and 13. When you
boot the system, you are loading the Exec into the system from the boot tape and
then initializing the system.
Note: Enter N in response to the TIP INITIALIZATION message.
For additional information on booting the Exec, refer to the Exec System Software
Installation and Configuration Guide.
3. Beginning with ClearPath OS 2200 Release 12.1 a new fast-load tape is provided for
the Dorado 400 systems. Dorado 400 sites must use the CP-FLD400 fast-load tape.
All other systems continue to use the CP-FLD fast-load tape.
Install the products contained on the first-load (CP-FLD or CP-FLD400) fast-load tape
(refer to the following table).
If you are a non-Dorado 400 site, install these products quickly by using the ST
INSTALLFLD command.
If you have a Dorado 400 system, you must use the ST INSTALLPKG runstream to
install the CP-FLD400 fast-load tape. Additional input is required with this runstream
for installing the CP-FLD400 tape. You will be prompted to provide the Logical
Package name, CP-FLD400 and the Package Level, 13.2.
The SOLAR full-screen interface can also be used to register and install these
products.
Note: If you use the full-screen interface for installing CP-FLD, CP-FLD400 or CP01
products, sign off from your demand terminal and wait until the batch install
runstream finishes. Then, reenter the full-screen interface and continue with your
installation.
7831 0349–043 7–27