ClearPath OS 2200 Series Release 13.2 Software Planning and ...

Software License Management
3.5.5. Registering Your Software Product Keys
For ClearPath OS 2200 Release 10.0 and higher, use SOLAR to register software
product keys. When the keys are registered, SOLAR verifies that the SCN on the
software product key tape complies with the value of the SCN in the Exec Image Enabler
key.
There are two scenarios, depending on the format of the Image Enabler key.
• Old format Image Enabler key
The Image Enabler key is in the old format if it does not contain an SCN value. In this
case, the SCN value from the software product key tape is loaded into the Exec
Image Enabler key when the ClearPath OS 2200 software product key tape is
registered and the system is in compliance.
• New format Image Enabler key
The Image Enabler key is in the new format when it contains an SCN value.
− When the SCN value on the software product key matches the SCN value on the
Image Enabler key, the system is in compliance.
− When the SCN value on the software product key does not match the SCN value
on the Image Enabler key, the system is not in compliance.
If you are running in batch mode, a console message is displayed informing you
that a noncompliance has occurred and that there are informational messages in
the diagnostic file. To become compliant, you must register the proper software
product key tape. Find the SCN value displayed on the label of your software
product key tape. Register the software product key tape that matches the SCN
displayed when you use the MODELNUM keyin. After registration, your partition
will be in compliance.
Note: To determine the SCN and MCN values on your Image Enabler key that
have been registered, use the MODELNUM keyin. Exec level 47R5 or higher
shows both values. Earlier Exec levels show only the MCN.
3–20 7831 0349–043