1935 Cadillac - GM Heritage Center

77
COOLING SYSTEM
Fig. 18
Remove the six screws under the anti-squeak strip
attaching the radiator casing to the core. (Three each
side)
Remove all bolts attaching the front fenders to the
radiator casing beginning with the bolt under the
fender brace and continuing to the extreme front of
the "car. Also remove the two bolts holding the dust
shield to the casing. After removing the fender bolts,
loosen but do not remove the four bolts attaching the
fender brace to the frame
Fig. 20
Spread the fenders outward by pulling on the outer
edge of the fenders and at the same time pull the
bottom of the radiator grill straight forward approximately
three inches
-
Fig. 21
F i g 1 9
Remove the fender lace between the fender and the ,.. .
radTator casing on both sides. Also remove the anti- Lift the casing upward, sliding it over the core until it
Sueak bet^ween the lower grill and the fender on both is free of the fenders; then remove it from the core.
squeaK oetween me e
T h e d u g t g h i e l d w i U d r o p o u t o f t h e c a s i n g.
Plate 25. Removal of Radiator Casing