1935 Cadillac - GM Heritage Center

Fisher Body Service Manual, 1935
DOOR ARM REST
To Remove:
1. Remove two long Screws from underside of Arm Rest.
2. Lift Arm Rest from Bracket.
TO REMOVE REAR DOOR GLASS
1. Remove the Garnish Molding.
2. Remove the Glass Run Channel Upper.
3. Remove the two Wood Corner Blocks.
4. Raise Glass, disconnect it from the Regulator Arm and
remove from Door.
Front Door Window
Regulator (Sedan).
Illustration No. 75
Door Arm Rest Removal.
TO REMOVE FRONT DOOR GLASS
1. Remove Window Garnish Molding.
2. Remove Upper Glass Run Channel (See Illustration No.
76 at A).
3. Remove (2) Screws from Center Division Channel at
Door Header.
4. Remove Door Ventilator Handle and Door Safety Locking
Rod Handle.
Illustration No. 77
Front Door Window
Regulator (Coach).
DOOR WINDOW REGULATOR
To Remove:
1. Remove Garnish Molding and Arm Rest.
2. Remove all Door Handles and the Safety Locking Rod
Handle.
3. Loosen Door Trim Pad and remove it from Door.
4. Remove Sash Channel Cam Screws (2 screws in each
end).
5. Remove Regulator Board.
6. Remove Regulator.
Illustration No. 76
Front Door Glass Removal.
5. Loosen the Door Trim Pad at Window Opening and remove
the top section of the Regulator Board.
6. Remove (3) screws from Center Division Channel at "B."
7. Loosen the Lower Half of Door Trim Pad and remove
(2) screws at lower end of Center Division Channel at
"D."
8. Remove the two screws at each end of the Glass Sash
.Channel at "C."
9. Remove Glass from Window Opening.
Illustration No. 78
Front Door Window Regulator Board and Mechanism.
Page 23