1935 Cadillac - GM Heritage Center

Fisher Body Service Manual, 1935
3. Tack front end of Headlining- to the tacking strip above
the Windshield.
4. Apply paste to the back of the Over Windshield Trim
Strip and refasten to place with brads drawing Trim
over the head of the brad.
5. Tuft the Headlining under the lower edge of the Headlining
Retainer Plates above the Doors and tack Headlining
to the Rear Window Frame.
LOWER REAR QUARTER TRIM REMOVAL
The Rear Quarter Arm Rest is a part of the Rear Quarter
Lower Trim Assembly. This Assembly including the Arm
Rest is made up of a waterproof Foundation Board formed to
fit the contour of the Wheel Housing (See Illustration No. 91
at A.) over which the Foundation Wadding and Trim Material
are assembled. To remove the Rear Quarter Lower Trim Assembly
proceed as follows :
1. Remove the Rear Seat Cushion and Cushion Back:
Illustration No. 89
Headlining Installation Tool.
6. Tack the Headlining to the Rear Seat Parcel Shelf Board
and over Rear Quarter Windows and at the Rear Quarter
Upper Trim Strip.
7. Reinstall Rear Quarter Upper Trim Pad with brads and
draw the Trim over brad heads.
8. Tack and cut out Headlining at Dome Lamp Block, and
install Dome Lamp Assembly.
9. Tack the Rear Seat Parcel Shelf Board Trim in place.
10. Install Rear Window Garnish Molding and Rear Window
Curtain.
11. Install the Rear Seat Back Assembly. Rear Seat Cushion
and retack the cardboard to the rear of Seat Back Assembly.
NOTE—For a description of Headlining removal and replacement
on later 1935 Body Styles. (See Index.)
Illustration No. 91
Lower Quarter Trim Partially Removed.
2. Remove Rear Quarter Window Garnish Molding.
3. Remove Rear Quarter Window Regulator or Ventilator
Handle.
4. On the outside of the car, remove the screw from under
the Wheelhousing holding Arm Rest in place. (See Illustration
No. 92 at B.)
5. Turn back the Floor Carpet and remove tacks from Tacking
Strip holding Trim Assembly to Sill and Rear Body
Hinge Pillar.
6. Remove tacks from Trim Stick holding Trim Assembly
at the Rear.
Illustration No. 92.
Lower Quarter Trim Removal.
Illustration No. 90
Parcel Shelf Board Trim.
7. Remove tacks holding Trim Assembly to the top edge of
the Rear Quarter Regulator Board. After this operation,
turn down the Trim Material and remove the tacks holding
the Cardboard Foundation of the Assembly to the
Regulator Board. (See Illustration No. 91 at A.)
8. Carefully pry loose the Trim and Cardboard Foundation
from the Rear Body Hinge Pillar.
Page 28