1935 Cadillac - GM Heritage Center

Fisher Body Service Manual, 1935
1935 REMOVAL AND REPLACEMENT
DOOR OUTSIDE LOCKING
HANDLE
The Door Outside Handle, (Right) has a Locking Cylinder
and Key. The Handle is a hollow shell into which the Cylinder
and detachable Shaft is housed.
To remove the Cylinder, simply drive out the Pin, (See Illustration
No. 68) and pull out the Cylinder with the Key.
The Cylinder is removed from its Shaft Assembly by sliding
the Sleeve from the Cylinder down on the Shaft and disconnecting
the Shaft from the Cylinder.
To remove the Door Outside Handle, remove with a small
screw driver the Retainer Screw to be seen through a hole in
the face of the Door Lock. This screw when taken out will
release the Handle to be pulled out of the Door.
Note: On the larger Bodies a Finishing Plate must be removed
to expose this Retaining Screw. Illustration No. 59
shows the various parts of the Door Outside Locking Handle
Assembly.
On the later type 1935 Bodies the Front Door Inside Pull to
Handle was applied on the inside of the Door Outside Handle
and retained by a small screw through the Inside Handle.
Illustration No. 68
Outside Door Handle Lock Cylinder Removal.
After reassembling the Cylinder to the Handle again, make
sure the Retaining Pin is inserted and swaged to secure it to
place.
Illustration No. 70
1935 Glove Compartment Lid.
GLOVE
COMPARTMENT
The Glove Compartment Box may be removed by taking out
two screws at the top, one screw on each side and three at the
bottom around the inside of the Glove Compartment Box opening.
The Lid is removed by taking out one screw through the
Support Bracket and the two screws in each of the Hinges.
Illustration No. 69 Illustration No. 71
Location of Outside Door Handle Retaining Screw.
1935 Glove Compartment Lock Cylinder Removal.
Page 21