1935 Cadillac - GM Heritage Center

Fisher Body Service Manual, 1935
3. Remove the Door Outside Handle.
4. Remove the screws in Lock Face.
5. Loosen the Door Trim Pad near the Lock and remove the
screws in the Lock Casing.
6. Remove Lock by disengaging it from the Remote Control
. Link.
Illustration No. 79
Front Door Ventilator Assembly.
DOOR VENTILATOR
ASSEMBLY
To Remove:
1. Remove Door Garnish Molding.
2. Remove Ventilator Regulator Handle.
3. Loosen Door Trim Pad at top.
4. Remove top section of Regulator Board.
5. Remove ten screws from Retainer and Regulator Base.
, 6. Remove the entire Assembly.
DOOR VENTILATOR REGULATOR
A new Door Ventilator Regulator may be replaced on the
Assembly-by removing the entire Assembly from the Door and
cutting the two white metal lugs and two rivets in the Regulator
Back Plate then by removing the "Hex" screw, remove
the old Regulator.
Rivet the New Regulator to place and install in Door.
Illustration No. 81
Rear Quarter Window Regulator Board Removal.
REAR QUARTER REGULATOR
BOARD
To Remove:
1. Remove Rear Seat Cushion.
2. Remove Rear Seat Back.
3. Remove Quarter Window Garnish Molding.
4. Remove Regulator Handle.
5. Draw the tacks on Trim Pad and its foundation Board
along the Window Opening and down far enough to clear
the Regulator Board.
6. Remove Regulator Board. (A Wood Screw going up
from the outside under the Fender Anchors the Arm Rest
to the Wheelhousing in some Style Bodies. Remove this
screw.)
REAR QUARTER VENTILATOR ASSEMBLY
(SEDAN)
To Remove:
1. Remove the Garnish Molding.
2. Remove the Regulator Handle.
3. Release the Lower Quarter Trim along Window Opening.
4. Remove Screws holding the Ventilator Assembly to the
Window Framing.
5. Loosen the Assembly and Remove towards inside of car.
BACK WINDOW
GLASS
To Remove:
1. Remove Garnish Molding.
2. Loosen Glass in Channel and remove Glass. On some
Styles it is necessary to remove the Curtain.
Illustration No. 80
Door Lock Removal.
FRONT DOOR
LOCK
To Remove:
1. Remove the Garnish Molding.
2. Remove Inside Safety Lock Rod Handle. (Unscrew the
Escutcheon Nut)
REAR SEAT BACK
To Remove:
1. Remove Rear Seat Cushion.
2. Remove two screws at the Floor that hold the Seat Back
Frame.
3. Through Rear Compartment or Trunk Opening, remove
tacks holding the cardboard Baffle to the Rear Seat Back
Frame, then remove three screws entering the top of
Rear Seat Back.
4. Lift out the Seat Back.
Page