Kawasaki Z1000 - ZR1000 2003-04 Service Manual - Small Engine ...

Not For Resale
www.SmallEngineDiscount.com
Swingarm
SUSPENSION 13-21
Swingarm Installation
• Apply plenty of grease to the ball bearing, needle bearings
and grease seals, and add plenty of grease to the grease
nipple.
• Install the collars [A].
○Place the right collar [A] on the stopper [B] inside the
frame [C].
Insert the pivot shaft into the frame from the right side.
• Tighten the pivot shaft so that the clearance [D] between
the collar [A] and the frame [C] come to zero mm.
• Tighten:
Torque - Swingarm Pivot Shaft Nut: 127 N·m (13 kgf·m, 94
ft·lb)
• Tighten the pivot locknut, using the socket wrench.
Special Tool - Socket Wrench: 57001–1370
Torque - Swingarm Pivot Shaft Locknut: 98 N·m (10.0
kgf·m, 72 ft·lb)
Swingarm Bearing Removal
• Remove:
Swingarm
Collars [A]
Grease Seals [B]
Sleeve [C]
Circlip (right side) [D]