Kawasaki Z1000 - ZR1000 2003-04 Service Manual - Small Engine ...

Not For Resale
www.SmallEngineDiscount.com
Cable, Wire, and Hose Routing
APPENDIX 17-11
1. Clamp all the wires as shown in the encircled area.
2. Meter
3. Take out the lead of the meter from the right side of the tie lap to connect with the meter.
4. Clutch cable
5. Starter cable
6. To front left turn signal light (Run the harness above the bolt for fairing installation.)
7. Run the ignition switch lead front the clutch cable and starter cable.
8. To left switch housing
9. Run the leads for the clutch starter and the ignition switch in order from the head pipe then run
the cables with their acceleration side facing outward.
10. Headlight high and low
11. Install the lead with its inner side facing inward.
12. Running position light
13. To right switch housing
14. Throttle cable (Run the cable through the front of main harness.)
15. Brake hose (to caliper right side)
16. To front right turn signal light (Run the harness above the bolt for fairing installation.)
17. Seat lock
18. Seat lock cable