5ml User's Guide

CHAPTER 13: Using Layout and Navigation Widgets
Figure 13-6: Placing two Rectangle elements within a 3D Stage element.
If you change the element's Origin value, then you will offset its vanishing point from the 3D Stage element's vanishing
point, as shown with rectangle B in Figure 13-7 on page 318.
Figure 13-7:Changing Rectangle B's Origin X and Y values to offset its vanishing point.
To change the 3D Stage element's properties, click the element on the page, or click 3D Stage in the Page Outline pane.
The Properties pane for the 3D Stage element appears on the right side of the Project Editor with the following tabs:
• The General tab lets you define the element's optional ID. For details, see "Changing General Properties" on page
197.
• The Appearance tab lets you set the element's border and opacity, and add a reflection and shadow to the element.
These settings are applied to the entire Container element; to change the appearance settings for each
- 318 -