AJA FS1 Installation and Operation Guide

96
No Action (default)
Alarm
GPI 1 Out (37.1)
No Video
No Ref
Vid In SDI1
Vid In SDI2
Vid In Cmpst
Vid In S-Vid
Vid In Cmpnt
No Action (default)
Alarm
GPI 2 Out (37.2)
No Video
No Ref
Vid In SDI1
Vid In SDI2
Vid In Cmpst
Vid In S-Vid
Vid In Cmpnt
Unlocked (default)
Locked
Disabled (default)
Basic
FS1 will not trigger a GPI 1 output trigger regardless of event.
FS1 generates a GPI 1 output trigger on pin 3 if an internal alarm condition occurs (GPI DE-
9 Connector). See Chapter 2 for alarm descriptions.
FS1 generates a GPI 1 output trigger on pin 3 if no video is detected at its selected input.
FS1 generates a GPI 1 output trigger on pin 3 if no video is detected at its Ref video input.
FS1 generates a GPI 1 output trigger on pin 3 if SDI1 is selected as the main video input.
FS1 generates a GPI 1 output trigger on pin 3 if SDI2 is selected as the main video input.
FS1 generates a GPI 1 output trigger on pin 3 if Composite is selected as the main video input.
FS1 generates a GPI 1 output trigger on pin 3 if S-Video is selected as the main video input.
FS1 generates a GPI 1 output trigger on pin 3 if Component is selected as the main video input.
FS1 will not trigger a GPI 2 output trigger regardless of event.
FS1 will generate a GPI 2 output trigger on pin 4 if an internal alarm condition occurs (GPI
DE-9 Connector). See Chapter 2 for alarm descriptions.
FS1 will generate a GPI 2 output trigger on pin 4 if no video is detected at its selected input.
FS1 will generate a GPI 2 output trigger on pin 4 if no video is detected at the Ref input.
FS1 generates a GPI 2 output trigger on pin 4 if SDI1 is selected as the main video input.
FS1 generates a GPI 2 output trigger on pin 4 if SDI2 is selected as the main video input.
FS1 generates a GPI 2 output trigger on pin 4 if Composite is selected as the main video input.
FS1 generates a GPI 2 output trigger on pin 4 if S-Video is selected as the main video input.
FS1 generates a GPI 2 output trigger on pin 4 if Component is selected as the main video input.
Front Panel Lock Out—When set to Locked, this setting locks out FS1 front panel
access, the same as setting 35.1 to REMOTE ONLY. This menu can be enabled or
disabled only from the web browser.
Panel will respond as set in 35.1 REMOTE CONTROL.
Lock out front panel access; the same as setting 35.1 to REMOTE ONLY.
Authentication (35.3)—Setting determines whether password protection is applied to
the FS1 web browser interface.
Selects no password protection.
Selects password protection. When selected you will be prompted for a Name and Password.
Ignore the Name field, but enter the correct password to allow web access. The factory value
for password is password—if you select Basic Password you will have to initially enter the
factory password before you can enter a new password using the Set Password field below
Authentication. Once a password is entered, enter the same exact password in the Confirm
Password field and then click the Change Password button to the right of it. Please read the
“Notes” below.