AJA FS1 Installation and Operation Guide
AJA FS1 Installation and Operation Guide
AJA FS1 Installation and Operation Guide
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
52<br />
6.4 Analog Output Fine (Horizontal Timing)<br />
7.1 Sidebar Keyer<br />
Further adjusts the horizontal output timing of the analog output (only) in finer<br />
increments than 6.2 (above)—in this case by sub-pixels. Each adjustment of this<br />
control, from 0 to 127 adjusts the analog output timing by 1/128th of a pixel. Like<br />
6.2, horizontal output timing is adjusted with reference to the Ref video selected.<br />
6.4 Analog Output Fine Description of Choices<br />
Parameter Adjustments:<br />
Variable Adjustment range increments from 0 to 127, with each increment moving the timing<br />
by 1/128th of a pixel.<br />
Default: 0<br />
This parameter turns the Sidebar Keyer On or Off, <strong>and</strong> selects its source. When<br />
turned On, the <strong>FS1</strong> Sidebar Keyer takes a st<strong>and</strong>ard definition signal from the<br />
selected input source (parameter 2.1), upconverts it, <strong>and</strong> then adds HD sidebars<br />
from the source selected here in parameter 7.1.<br />
The sidebars keyed over the <strong>FS1</strong>’s source video (2.1) will each have a width as<br />
specified in parameter 7.2. Sidebar video is useful when upconverting st<strong>and</strong>ard<br />
definition video in 4:3 Pillar mode, as the sidebar takes the place of the black on the<br />
sides of the 4:3 aspect ratio picture.<br />
The input selected here (7.1) for the Sidebar must be an HD signal, <strong>and</strong> it must be<br />
the same format as that selected for parameter 1.1 Output Format.<br />
Notes:<br />
1. It is normal for SD sources used for the sidebar fill to sometimes have<br />
asymmetrical edges (if SD video isn’t cropped to “real video”). This can be seen<br />
in some cases where digital video was digitized from analog.<br />
2. The Composite <strong>and</strong> S-Video inputs are not available as the sidebar source since<br />
they only support SD.<br />
The Component input may be used as a sidebar input source for 7.1—but only if the<br />
main input selected by 2.1 is not Composite or S-Video. (There is only one A/D<br />
converter in the <strong>FS1</strong>, <strong>and</strong> it cannot be used for both inputs simultaneously.)<br />
7.1 Sidebar Keyer Description of Choices<br />
Parameter Adjustments:<br />
OFF (default)<br />
SDI 1<br />
SDI 2<br />
Component<br />
Turn the Sidebar Keyer off.<br />
Turn the Sidebar Keyer on <strong>and</strong> route the video from the SDI 1 input into it.<br />
Turn the Sidebar Keyer on <strong>and</strong> route the video from the SDI 2 input into it.<br />
Turn the Sidebar Keyer on <strong>and</strong> route the video from the Component analog input<br />
into it.