AJA FS1 Installation and Operation Guide
AJA FS1 Installation and Operation Guide
AJA FS1 Installation and Operation Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
80<br />
SDI 1 (default)<br />
SDI 2<br />
Composite<br />
S-Video<br />
Component<br />
NTSC (default)<br />
NTSC Japan<br />
Embed Auto<br />
(Follows Video Input select)<br />
Embed SDI 1<br />
Embed SDI 2<br />
AES unbal (default)<br />
Analog<br />
59.94/23.98 (default)<br />
60/24<br />
50/25<br />
Beta YPbPr<br />
SMPTE YPbPr (default)<br />
Beta YPbPr<br />
SMPTE YPbPr (default)<br />
RGB<br />
+24 dBu (default)<br />
+18 dBu<br />
+15 dBu<br />
+12 dBu<br />
Video In (2.1)<br />
Select SDI 1 connector as the input source.<br />
Select SDI 2 connector as the input source.<br />
Select the Composite connector as the input source.<br />
Select the S-Video connector as the input source.<br />
Select the Component connector as the input source.<br />
NTSC St<strong>and</strong>ard (3.4)<br />
Select NTSC for US NTSC st<strong>and</strong>ard.<br />
Select NTSC Japan for the Japanese NTSC st<strong>and</strong>ard.<br />
Audio In (2.2)<br />
Use the embedded audio from the currently selected Video Input (SDI 1 or 2) as the input<br />
source. (This defaults to SDI 1 if Video In is not SDI.)<br />
Use the embedded audio from the SDI 1 connector as the input source.<br />
Use the embedded audio from the SDI 2 connector as the input source.<br />
Select thedigital AES/EBU Audio connectors (8-ch) as the audio input source.<br />
Select the Analog Audio connector (DB25, 8-ch) as the audio input source.<br />
Frame Rate (3.3)<br />
Select the 59.94/23.98 item if your desired rate is either 59.94 or 23.98.<br />
Select the 60/24 item if your desired rate is either 60 or 24.<br />
Select the 50/25 item if your desired rate is either 50 or 25 (PAL).<br />
Component In (3.1)<br />
Configure the Component video input source as Beta YPbPr (st<strong>and</strong>ard definition). If the<br />
selected Component video source is HD, this will default to SMPTE YPbPr.<br />
Configure the Component video input source as SMPTE YPbPr.<br />
Component Out (3.2) Signal Type<br />
Configure the Component video output as Beta YPbPr (st<strong>and</strong>ard definition). If the<br />
Component video is HD, this will default to SMPTE YPbPr.<br />
Configure the Component video output as SMPTE YPbPr.<br />
Configure the Component video output as RGB.<br />
Analog Audio St<strong>and</strong>ard (4.1)<br />
Select +24 dBu as the analog audio level.<br />
Select +18 dBu as the analog audio level.<br />
Select +15 dBu as the analog audio level.<br />
Select +12 dBu as the analog audio level.<br />
Maximum amplitude (0 dBFS)
Change language