AJA FS1 Installation and Operation Guide
AJA FS1 Installation and Operation Guide
AJA FS1 Installation and Operation Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>FS1</strong> Simple Network Management Protocol<br />
Chapter 6:<br />
SNMP<br />
SNMP is defined as a “simple network management protocol” <strong>and</strong> was specified as a<br />
component of the internet protocol suite by the Internet Engineering Task Force<br />
(IETF). The <strong>FS1</strong> can act as a network element that issues SNMP trap messages<br />
signalling a detected alarm condition or other system condition.<br />
Before the <strong>FS1</strong> can respond to SNMP requests, parameter 51.1 must be set to<br />
enable SNMP communication.<br />
51.1 SNMP Enable Description of Choices<br />
Parameter Adjustments:<br />
Disable (Default)<br />
Enable 1<br />
Enable Both<br />
When set to Disable, the <strong>FS1</strong> will not issue SNMP trap messages.<br />
When set to Enable 1, the <strong>FS1</strong> issues SNMP trap messages to Trap Destination 1<br />
(parameter 51.2) <strong>and</strong> as defined in the MIB.<br />
When set to Enable Both, the <strong>FS1</strong> issues SNMP trap messages to Trap Destination<br />
1 <strong>and</strong> 2 (parameters 51.2 <strong>and</strong> 51.4) <strong>and</strong> as defined in the MIB.<br />
When SNMP is enabled, one or more of 4 alarms may be sent by the <strong>FS1</strong> to the<br />
client NMS as a trap message:<br />
Power supply failure or disconnection: fs1PSAlarm (see parameter 60.1)<br />
Reference video: fs1REFAlarm (see parameter 60.3)<br />
Format: fs1FMTAlarm (see parameter 60.2)<br />
Temperature of <strong>FS1</strong> is over limit (internally): fs1OVRAlarm<br />
61
Change language