Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

B–62755EN/013. INPUT AND OUTPUT OF DATA3.3.2Input and Output of EachFileYou can input and output files individually.Execute the same operations from step 1 to 6 in the previous section 3.3.1.(1)Reading or Punching default files7 Press [DEF. FILE].8 For reading, input a file no. for default data and press soft key[READ EXEC]. (Specify a file number of default file). For punching, press [PUNCH EXEC].(2)Reading or punching pre–tool list7 Press PRE–TOOL.8 For reading, press a file number and soft key [READ EXEC].(Specify a file number of pre–tool list). For punching, press soft key [PUNCH EXEC].(3)Reading or Punching tool file7 Press TOOL FILE.8 For reading, press a file number and pres soft key[READ EXEC]. (Specify file number of tool file). For punching, press [PUNCH EXEC].(4)Reading or Punching F, S file7 Press F.S. FILE.8 For reading, press a file no. and press soft key[READ EXEC].(Specify a file no. of F.S. FILE). For punching, press [PUNCH EXEC].3.3.3 This feature allows NC parameters, offsets, NC programs, PMCparameters and so on to be input/output from/to a general I/O device suchas FANUC cassette adapter or the like.1. Data that can be input/output(1) NC parameters: All parameters except for optional parametersand a parameter that specifies the no. ofaxes.(No. 1010)(2) Offset values: All data of wear/geometry data(3) NC programs: All the NC programs(4) PMC parameters: All data of counter, keep relay, timer and otherdata(5) Tool File: All data of tool data file, F.S. data, roughnessdata, pre–tool list and chuck/tailstock figuredata.(6) CAP program: All the CAP program (Cannot input/outputindividual program)CAUTIONYou should input/output NC parameters separately. Youcan input/output other data in a lump.197