Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

1. DISPLAY AND OPERATION OF CRT/MDI B–62755EN/011.10.2Waveform DiagnosticParameter Screen1.Press the SYSTEM key to display a system screen such as aparameter.2. Press the next menu key several times, and the soft key[W.DGNS] is displayed.3. Press [W.DGNS], then the parameter screen for the waveformdiagnosis is displayed.Set the necessary data items. Position the cursor to the item to be set,enter the corresponding data, then pressIN-PUT. Data items for which***** is displayed cannot be set. To assist in data setting, the frame onthe right side of the screen displays help information for that data to whichthe cursor is positioned. Help information which cannot fit into a singleframe is split into several pages, which the user can scroll through usingthe page keys and .WAVE DIAGNOSE (PARAMETER)GRP CONDITION 100O1234 N12345GRP CONDITIONSAMPLING TIME *****MSTRIGGER *******(CH–1)(CH–2)DATA NO. 11 22UNIT 1000 10SIGNAL ******* *******(ONE–S TYPE)0:START1:START&TRG ↑2:START&TRG ↓(MEMORY TYPE)100: DATA OFMEMORY1/3> S 0 T0000EDIT **** *** *** 08:20:52[W.PRM] [W.GRPH] [ W.MEM ] [ ] [ ] Waveform diagnosisparameters (one–shottype)(1)Display start condition0 : Starts data sampling upon the [START] key being pressed,samples data for the specified period, then draws a waveform.1 : Starts data sampling upon the detection of the first rising edge ofthe trigger signal after the [START] key is pressed, samples datafor the specified period, then draws a waveform.2 : Starts data sampling upon the detection of the first falling edge ofthe trigger signal after the [START] key is pressed, samples datafor the specified period, then draws a waveform.(2)Sampling period: Set the period during which data will be sampled.Valid data range: 10 to 32760Units: ms(3)Trigger: Set the PMC address and bit for the signal used to trigger thestart of data sampling, when 1 or 2 is set for the start condition.Example)G0007.2: ST signal70