Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

INDEXB–62755EN/01Deleting file name and files, 208Deletion of external operator messages record, 28Description of this manual, 1Digital servo, 247Display and operation of CRT/MDI, 1Display method, 24, 51, 218, 270Displaying diagnostic page, 54Displaying servo tuning screen, 254Dogless reference position setting, 259Dump/restore of CAP–II data (16–T), 207EEnvironmental requirement, 125Error messages and required actions, 495Execution period of PMC, 217External operator message record, 28FFor lathe, 263Function keys and soft keys, 2Fuse replacement in power supply unit, 174Fuses, 416GGeneral of hardware, 92General of interface, 211General of spindle control (analog interface), 280General of spindle control (serial* interface), 262Graphic of wave diagnosis data, 73Graphic screen (M series), 21Graphic screen (T series), 20HHandle operation cannot be done, 310Hardware, 90Hardware configuration, 414Help function, 51Help screen, 19High–speed DI signal interface, 123How to replace fan motor, 172How to replace the batteries, 168How to replace the modules, 167How to replace the monochrome liquid crystal display, 180II/O card (sink type output), 148I/O card (source type output), 148I/O cards with power supply (power C) (sink type output), 149I/O cards with power supply (power C) (source type output),150I/O link, 109I/O unit model A, 413Initial setting servo parameters, 248Input and output of data, 183Input and output of each file, 197Input/output of conversational data in a lump (super CAP M),195Input/output super CAP data, 195Inputting and outputting the operation history data, 44Inputting CAP data (super CAP T), 202Inputting CNC parameters, 190Inputting custom macro variable values, 192Inputting part programs, 193Inputting pitch error compensation amount, 192Inputting PMC parameters, 191inputting tool compensation amount, 193Inputting/outputting CAP–II data (16–T), 205Inputting/outputting data, 186Insertion, 167Inter–machine connection, 98Interface between NC and PMC, 210Investigating the conditions under which failure occurred, 297JJog operation cannot be done, 306KKind of data in sub memory, 207LLED display and module configuration of PCB, 131LED indication, 415List of alarm codes, 420List of alarms (PMC), 447List of maintenance parts, 462List of operations, 82List of parameter, 290List of serial interface spindle amplifier alarms, 389List of signals by each mode, 237List of the PCBs and units, 154LOAD BASIC SYSTEM function, 493Loader control board, 146i–2