Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

B–62755EN/01APPENDIXB. ALARM LISTNumberMessageContents021 ILLEGAL PLANE AXIS COMMAN-DEDAn axis not included in the selected plane (by using G17, G18, G19) wascommanded in circular interpolation. Modify the program.022 NO CIRCLE RADIUS The command for circular interpolation lacks arc radius R or coordinateI, J, or K of the distance between the start point to the center of the arc.023 ILLEGAL RADIUS COMMAND(T series)025 CANNOT COMMAND F0 IN G02/G03(M series)027 NO AXES COMMANDED ING43/G44 (M series)In circular interpolation by radius designation, negative value was commandedfor address R. Modify the program.F0 (fast feed) was instructed by F1 –digit column feed in circular interpolation.Modify the program.No axis is specified in G43 and G44 blocks for the tool length offset typeC.Offset is not canceled but another axis is offset for the tool length offsettype C. Modify the program.028 ILLEGAL PLANE SELECT In the plane selection command, two or more axes in the same directionare commanded.Modify the program.029030ILLEGAL OFFSET VALUE(M series)ILLEGAL OFFSET VALUE(T series)ILLEGAL OFFSET NUMBER(M series)ILLEGAL OFFSET NUMBER(T series)The offset values specified by H code is too large.Modify the program.The offset values specified by T code is too large.Modify the program.The offset number specified by D/H code for tool length offset or cuttercompensation is too large. Modify the program.The offset number in T function specified for tool offset is tool large.Modify the program.031 ILLEGAL P COMMAND IN G10 In setting an offset amount by G10, the offset number following addressP was excessive or it was not specified.Modify the program.032 ILLEGAL OFFSET VALUE IN G10 In setting an offset amount by G10 or in writing an offset amount by systemvariables, the offset amount was excessive.033034035NO SOLUTION AT CRC(M series)NO SOLUTION AT CRC(T series)NO CIRC ALLOWED IN ST–UP /EXTBLK (M series)NO CIRC ALLOWED IN ST–UP /EXTBLK (T series)CAN NOT COMMANDED G39(M series)CAN NOT COMMANDED G31(T series)036 CAN NOT COMMANDED G31(M series)CAN NOT CHANGE PLANE IN CRC(M seires)037CAN NOT CHANGE PLANE IN NRC(T seires)A point of intersection cannot be determined for cutter compensation.Modify the program.A point of intersection cannot be determined for tool nose radius compensation.Modify the program.The start up or cancel was going to be performed in the G02 or G03mode in cutter compensation C. Modify the program.The start up or cancel was going to be performed in the G02 or G03mode in tool nose radius compensation. Modify the program.G39 is commanded in cutter compensation B cancel mode or on theplane other than offset plane. Modify the program.Skip cutting (G31) was specified in tool nose radius compensationmode. Modify the program.Skip cutting (G31) was specified in cutter compensation mode.Modify the program.G40 is commanded on the plane other than offset plane in cutter compensationB. The plane selected by using G17, G18 or G19 is changedin cutter compensation C mode. Modify the program.The offset plane is switched in tool nose radius compensation.Modify the program.421