Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

B–62755EN/011. DISPLAY AND OPERATION OF CRT/MDI Cause of the cycle startLED turned off020 CUT SPEED UP/DOWN021 RESET BUTTON ON022 RESET AND REWIND ON023 EMERGENCY STOP ON024 RESET ON025 STOP MOTION OR DWELLInput of emergency stop signalInput of external reset signalReset button On of MDIInput of reset & rewindServo alarm generationSwitching to other mode, Feed holdSingle block stop1 0 0 0 1 0 00 0 1 0 0 0 00 0 0 1 0 0 01 0 0 0 0 0 01 1 1 1 0 0 01 1 1 1 1 1 0 State of TH alarm Detail of Alarm 350 ofserial pulse coderDGN0202#7030 CHARACTER NUMBER TH ALARM Position of the character thatcaused TH alarm. The positionis counted from the head.031 TH DATA Data of the character that causedTH alarm.#6CSA#5BLA#4PHA#3RCA#2BZA#1CKA#0SPH Detail of Alarm 351 ofserial pulse coderDGN#6(CSA):#5(BLA):#4(PHA):#3(RCA):Hardware of serial pulse coder is abnormalBattery voltage is low (warning)Serial pulse coder or feedback cable is erroneous.Serial pulse coder is faulty.Counting of feedback cable is erroneous.#2(BZA): Battery voltage became 0.Replace the battery and set the reference position.#1(CKA):0203#0(SPH):#7DTESerial pulse coder is faulty.Internal block stopped.Serial pulse coder or feedback cable is faulty.Counting of feedback cable is erroneous.#6CRC#5STB#4 #3 #2 #1 #0#7(DTE):#6(CRC):#5(STB):Communication failure of serial pulse coder.There is no response for communication.Communication failure of serial pulse coder.Transferred data is erroneous.Communication failure of serial pulse coder.Transferred data is erroneous.55