Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

B–62755EN/01APPENDIXD. BOOT SYSTEMD.3ERROR MESSAGESAND REQUIREDACTIONSThe following table lists and explains error messages in alphabeticalorder.MessageDescription and required actionDFDELETE ERROR.HIT SELECT KEY.DEVICE ERROR (CNC x)D–RAM OR S–RAM PARITYFILE SAVE ERROR.HIT SELECT KEY.FLASH MEMORY NO SPACEFLASH ROM MODULE NOT EXIST.HIT SELECT.An attempt to delete a file from flash ROM was unsuccessful. Retry thedeletion. If the second attempt also fails, the flash ROM may havebeen damaged or destroyed. Replace the flash ROM module.An attempt to write data to flash ROM was unsuccessful. Retry thewrite operation. If the second attempt also fails, the flash ROM mayhave been damaged or destroyed. Repalce the flash ROM module.Invalid data has been found in the RAM area. If the RAM was notcleared after being installed, subsequently attempting backup maystop the BOOT SYSTEM and cause this message to be output.An attempt to write a file to a memory card was unsuccessful. Checkthat the memory card is not damaged.Note) Check that the memory card’s battery is not exhusted, that itscircuitry has not been damaged, and that it is securely insertedinto its slot.There is insufficient free flash ROM to store the selected file. Deleteany unnecessary files from flash ROM.The flash ROM module is not mounted on that CNC system. Put theflash ROM module on the board.I ILLEGAL FORMAT FILE The selected file cannot be read into flash memory. The selected fileor the header information for flash ROM may have been damaged ordestroyed.LLOADING ERROR.HIT SELECT KEY.An error occurred while loading data into flash ROM.Do not touch the memory card while loading data.495