Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

1. DISPLAY AND OPERATION OF CRT/MDI B–62755EN/011.11OPERATINGMONITORLoad meter of the servo axis and the serial spindle and the speed metercan be displayed.1.11.1Display Method1. Set a parameter to display operating monitor.3111#7#6 #5OPM#4 #3 #2 #1 #0#5:(OPM)0 : Operating monitor is not displayed. 1 : Operating monitor is displayed.2. Press the POS key to display the position display screen.3. Press continuous menu key , then soft key [MONI] is displayed.4. Press the soft key [MONI], then the operating monitor screen isdisplayed.OPERATING MONITOR(LOAD METER)O0001 N00001X : * * * 80% S1: 201%Y : * * * * * 0% (SPEED METER RPM)Z : * * * * * 0% S1: * * * 1500PART COUNT 5RUN TIME 0H15M CYCLE TIME 0H 0M38SACT.F 3000 MM/M S 0 T 0000[MEM STRT MTN *** 09:06:35[ ABS ] [ REL ] [ ALL ] [ HNDL ] [ OPRT ]CAUTION1 The bar graph for the load meter shows load up to 200%.2 The bar graph for the speed meter shows the ratio of thecurrent spindle speed to the maximum spindle speed(100%). Although the speed meter normally indicates thespeed of the spindle motor, it can also be used to indicatethe speed of the spindle by setting bit 6153. (OPS) ofparameter 311 to 1.3 The servo axes for their load meters are displayed are setto parameter No. 3151 to 3. If parameters 3151 to 3153 areall zero, the load meter of the basic axes are displayed.4 For 10″ LCD/14″ CRT, the bar of the load meter that exceed100% shows purple color.80