Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

4. INTERFACE BETWEEN NC AND PMC B–62755EN/01 Manual operationMODE INPUT/OUTPUT SIGNAL FEED RATE,ETCMANUALOPERATIONHandle/incrementalJOGZRN[PMC ⇒ CNC]HSnA∼D (Axis selection) n:1∼3(No. of MPGs)+α, –α (Jog feed)[PMC ⇒ CNC]RT (Rapid traverse)[PMC ⇒ CNC]ZRN(Reference position return mode)[MT ⇒ CNC]*DECα (Reference position deceleration)[CNC ⇒ PMC]ZPαZP2α, ZP3α, ZP4α(Reference position return completion)[PMC ⇒ CNC]MP1, MP2(Multiplier)[PMC ⇒ CNC]*JV0∼15(Manual fee-drate override)+α, –α (Manual feed movecommand)ROV1, ROV2HROV*HROV0∼6(Rapid traverseoverride) OthersOthers[PMC ⇒ CNC]MD1∼4 (Mode selection)*ESP (Emergency stop)KEY1∼4 (Memory protection key)MLK,MLKα (All axes/ each axis machine lock)*IT,*ITα (All axes/ each axis machine lock)*MITα (interlock per axis and direction:M series)STLK (Start lock:T series)*ABSM (Manual absolute)SVFα (Servo off)*FLWP (Follow up)ERS (External reset)RRW (Reset & Rewind)EXLM (Stored stroke limit external switching)LMα, RLSOT (Software limit external setting M series)*Lα (Overtravel limit)*EDα (External deceleration of each axis)[CMC ⇒ PMC]MA (NC ready)SA (Servo ready)AL (NC alarm)RST (Resetting)BAL (Battery alarm)INPα (In–position)MVα (Axis moving)TAP (Tapping)238