Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

B–62755EN/014.INTERFACE BETWEEN NC AND PMC Display of setting triggerThe setting address, condition and counter are displayed at the title line.“MODE:ON : X0000. 0 : 0 : 0001 ”COUNT: Trigger checking number (default 1)POINT: Trigger checking number (default 0)0 : the top of the 1st level1 : after END1 execution2 : after END2 execution3 : after END3 executionADR: Trigger setting addressON: Rising edge detection (TRGON)OFF: Falling edge detection (TRGOFF)* Setting form adr ;p1 ;p2+[TRGON/TRGOFF]soft keyNOTE“;”=”EOB” adr (trigger address) ;p1 (trigger point) ;p2 (triggerchecking number (1~65535))* Because parameters are stored in the nonvolatile memory, they are notlost even if the power is turned off.When bit 2 of keep relay K18 is set to 1 after parameters for samplingare specified, the trigger function automatically starts when the poweris turned on.For this operation, depress [TRIGER] soft key to bring the followingmenu.SEARCH ADRESS TRIGER WINDOWRETTRGON TRGOFF STARTNEXTDUMP DPARA TRGSRC INITThe function of the [TRIGER] soft key is explained below:(1)[TRGON] : The trigger function is stopped when a specified addresssignal goes high (is turned ON).(2)[TRGOFF] : The trigger function is stopped when a specified addresssignal goes low (is turned OFF).(3)[START] : Pressing this key switches between trigger functionexecution and trigger function termination. While thetrigger function is being executed, the ”TRG” indicationblinks.(4)[TRGSRC]: An instruction at which the trigger function has beenstopped by a specified address signal is searched for andindicated by blinking.(5)[INIT] : The trigger setting is initialized.221