Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

1. DISPLAY AND OPERATION OF CRT/MDI B–62755EN/01#1 (POS) A module required for spindle analog control is0 : not mounted1 : mounted#0 (SIC) A module required for spindle serial control is0 : not mounted1 : mountedDGNDGN0401 Serial spindle alarm state of 1st spindle0402 Serial spindle alarm state of 2nd spindleDGN0408#7SSA#6 #5SCA#4CME#3CER#2SNE#1FRE#0CRE#0 (CRE): A CRC error occurred. (Warning)#1 (FRE): A framing error occurred. (Warning)#2 (SNE): The transmission/reception target is invalid.#3 (CER): An error occurred during reception.#4 (CME): No response was returned during automatic scanning.#5 (SCA): A communication alarm occurred on the spindle amplifier side.#7 (SSA): A system alarm occurred on the spindle amplifier side.(These problems cause spindle alarm 749. Such problems are mainlycaused by noise, disconnection, or instantaneous power–off).DGN0409#7#6 #5 #4 #3SPE#2S2E#1S1E#0SHERefer to this diagnosis when alarm 750 has generated.#3 (SPE) In spindle serial control serial spindle parameters0 : Satisfy start condition of spindle unit1 : Do not satisfy start condition of spindle unit#2 (S2E) 0 : 2nd spindle started normally in spindle serial control.1 : 2nd spindle did not start normally in spindle serial control.#1 (S1E) 0 : 1st spindle started normally in spindle serial control.1 : 1st spindle did not start normally in spindle serial control.#0 (SHE) 0 : Serial communication module is correct on CNC side.1 : An error occurred in serial communication module on CNC sideDGNDGNDGN0410 Load meter of 1st spindle [%]0411 Speed meter of 1st spindle [%]0412 Load meter of 2nd spindle [%]58