Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

8. TROUBLESHOOTING B–62755EN/01G01240012#7DTCH8#7RMVx1) The control axis detach signal (DTCHn) is input.#6DTCH7#5DTCH6#4DTCH5#3DTCH4#2DTCH3#1DTCH2#0DTCH1If it is 1, the corresponding axis is detached.2) The following parameter enables the control axis detach function tothe corresponding axis.#6 #5 #4 #3 #2 #1 #0#7(RMVx)0 : Controlled axis is connected1 : Controlled axis is detachedg. CNC is waiting forspindle speed arrivalsignal to be inputActual spindle speed does not arrive at a speed specified in a program.Confirm the signal state using the PMC’s diagnostic function(PMCDGN).G0029#7#6 #5 #4SAR#3 #2 #1 #0#4(SAR) :When this signal is 0, spindle speed does not arrive at the specified speed.This function is valid when PARAM 3708#0=1.h. Manual feedrate overrideis 0% (dry run)Normally manual feedrate override function is used for jog feed.But when DRN(dry run) signal turns on during an auomaticoperation,override values set with these signals become valid to thefollowing speed set by a parameter.G0046#7DRN#6 #5 #4 #3 #2 #1 #0#7(DRN) : Dry run signal is input with this signal being 1.1410 Dry run rateG0010#7*JV7The rate when the following override value is 100%.#6*JV6#5*JV5#4*JV4#3+JV3#2*JV2#1*JV1#0*JV0↓ ↓ ↓G0011 *JV15 *JV14 *JV13 *JV12 +JV11 *JV10 *JV9 *JV8When override value is 0%, all bits of the above address is[1111 . . . . 1111] or [0000 . . . . 0000].*JV15. . . . . . . . . . . . . . JV0 Override1111 1111 1111 11111111 1111 1111 11101101 1000 1110 11110000 0000 0000 00010000 0000 0000 00000.00%0.01%:100.00%:655.34%0.00%318