Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

B–62755EN/018.TROUBLESHOOTINGc. Jog feedrate override is0%Check the signals using PMC’s diagnostic function (PMCDGN)G0010#7*JV7#6*JV6#5*JV5#4*JV4#3*JV3#2*JV2#1*JV1#0*JV0G0011 *JV15 *JV14 *JV13 *JV12 *JV11 *JV10 *JV9 *JV8When the override is 0% all bits of the above address becomes1111 . . . . 1111 or 0000 . . . . . 0000.*JV15 . . . . . . . . . JV0Override1111 1111 1111 11111111 1111 1111 11100.00%0.01%:1101 1000 1110 1111:0000 0000 0000 00010000 0000 0000 0000:100.00%:655.34%0.00%d. NC is in a reset stateIn this case, RESET is also displayed on the status display. Check it usingthe procedure of 1 above.2. When machinecoordinate value doesnot update on positiondisplayG0044#7(1) Machine lock signal (MLK) is input.#6 #5 #4 #3 #2 #1MLK#0G0108 MLK8 MLK7 MLK6 MLK5 MLK4 MLK3 MLK2 MLK1MLKMLKn: All axes machine lock: Each axis machine lockWhen the signal is 1, the corresponding machine lock signal is input.305