Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

3. INPUT AND OUTPUT OF DATA B–62755EN/01NC parameter9090 PMCIOSPMCIOS:The start address number of D area of the PMC parameters to beoutput.9091 PMCIOEPMCIOE:The end address number of D area of PMC parameters to be output.No.9090(PMCIOS)=0, No.9091(PMCIOE)=0: All the PMC parameters including keep relays, counters, timers and dataare output.No.9090(PMCIOS)=No.9091(PMCIOE) : 0: D area data (one data) of the specified address number is output.No.9090(PMCIOS) < No.9091(PMCIOE): D area data of PMC parameters from the specified starting address numberto the ending address number are output.No.9090(PMCIOS) > No.9091(PMCIOE): All the data in D area are output.3.3.4 The data output by the input/output in a lump function mentioned in 3.3.3can be input in a lump by the following operation;1. Set optional parameters required and the parameter for setting thenumber of axes (parameter no. 1010) beforehand.2. Connect an I/O device and set the corresponding parameters requiredas the same as output operation.3. Select EDIT mode. Select Head 1 screen for path 2.4. Release protection according to each data to input.1) NC parameter : Set setting data “PARAMETER WRITE” to 1.2) Offset amount : Turn off protection of offset data (KEY1=1).3) NC program : Turn off program protect (KEY3=1).4) PMC parameter : Set setting data “PARAMETER WRITE” to 1.5) Tool File : Turns off offset data protection (KEY1=1)6) CAP program : Turns off program protect (KEY3=1)202