Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

B–62755EN/011. DISPLAY AND OPERATION OF CRT/MDI Position error amountDGN0300 Position error of an axis in detection unitPosition error=Feed rate [mm/min]60servo loop gain [1/sec]×1Detection unit Machine positionDGN0301 Distance from reference position of an axis in detection unit Reference position shiftfunctionDGN Diagnostic data relatedto the Inductosynabsolute positiondetector302 Distance from the end of the deceleration dog to the first grid point[Data type] Two–word axis[Units of data] 0.001 mm (metric output), 0.0001 inch (inch output)[Valid data range] 0 to 99999999DGN380 Difference between the absolute position of the motor and offset dataM (absolute position of the motor) – S (offset data)λ(pitch interval)The remainder resulting from the division is displayed.[Data type] Two–word axis[Units of data] Detection unitsDGN Serial spindle381 Offset data from the InductosynOff set data is displayed when CNC calculates the machine position.[Data type] Two–word axis[Units of data] Detection unitsDGN0400#7#6 #5 #4SAI#3SS2#2SSR#1POS#0SIC#4(SAI)#3(SS2)#2(SSR)This data indicates the offset data received by the CNC while it iscalculating the machine coordinates.0 : Spindle analog control is not used.1 : Spindle analog control is used.0 : Spindle serial doesn’t control 2nd spindle.1 : Spindle serial control 2nd spindle.0 : Spindle serial control is not performed.1 : Spindle serial control is performed.57