Series 16/18/160/180-Model C Maintenance Manual, GFZ-62755EN ...

B–62755EN/014.INTERFACE BETWEEN NC AND PMC4.3.5 Inputting PMCparameters from the MDI1 Set to MDI mode or emergency stop state.2 Set PARAMETER WRITE (on setting screen) to 1 or set the programprotect signal (KEY4) to 1.PWEKEY4Timer –Counter Keep relay –Data table Either oneEither one3 Press a soft key and select a required screen.[TIMER] :Timer screen[COUNTR] :Counter screen[KEEPRL] :Keep relay screen[DATA] :Data table screen4 Press cursor key and move the cursor to a desired number.5 Input a numeric key and press INPUT key and data is input.6 After the data is input, set PARAMETER WRITE or KEY4 on settingscreen to 0. TIMER screenThis screen is used for setting timer time of the functional instruction(SUB 3).Page no. (screen is scrolled by page key)Timer no. specified by functional instructionAddress specified by ladderPMC PARAMETER (TIMER) #001MONIT RUNNO.ADDRESS DATA01 T00 48002 T02 96003 T04 004 T06 005 T08 006 T10 007 T12 008 T14 009 T16 010 T18 0NO.ADDRESS DATA11 T20 012 T22 013 T24 014 T26 015 T28 016 T30 017 T32 018 T34 019 T36 020 T38 0Timerdelaytime(msec)TIMER COUNTR KEEPRLDATATimer set time : Timer no. 1–8 is max. 1572.8 sec and its accuracy is48ms.Timer no. 9 is max. 262.1 sec and its accuracy is 8ms.231