B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Servicing Cylindrical PartsReinstalling therose liners1. Retract the rose locking pin, and rotate the outside rose linerclockwise until the proper door thickness groove on thethrough-bolt stud lines up with the hub face.This illustrationshows the chassisadjusted for a 21/4″ thick door.2 1/4″ Through-bolt stud2″1Hub faceOutside rose linerRose locking pinFigure 7.20Reinstalling the outside rose liner2. Release the rose locking pin. It should lock into the rose liner.Note: Make sure that the locking pin fully locks into the rose liner.3. From the outside of the door, insert the lock chassis into the 2 1/8″chassis hole, routing the motor wire through the notch.CautionCautionMake sure that the latch tube prongs engage the chassis frame andthat the latch tailpiece engages the retractor.4. Place the inside rose liner on the chassis, aligning the holes in therose liner with the holes prepared in the door.Make sure that there is clearance for the motor wire between the roseliner and the door.5. Install the through-bolts through the rose liner and door in the topand bottom holes.7–16 B.A.S.I.S. G Service Manual