B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Installation Instructions for B.A.S.I.S. EX Series Exit Hardware TrimOutside of LHRB doorFigure 2Outside of LHRB door4Figure 3Drilling the trim holes for use withPrecision Hardware exit hardwareDrilling the trim holes for use withVon Duprin exit hardwareOutside of RHRB doorOutside of RHRB doorBEST ACCESS SYSTEMSIndianapolis, IndianaPreparing the door5 Drill holes and mortise door surfaceCaution: Check for the correct lock function, hand,and bevel before drilling.1 Drill the trim holes listed below; follow the instructionson the trim template. See Figure 2 or Figure 3, andFigure 4.■ battery bracket hole— 7/16″ diameter— through door■ battery bracket/harness hole— 7/8″ diameter— through door■ escutcheon mounting holes— 7/16″ diameter— through door■ optional cylinder hole— 1 3/8″diameter for use with Precision Hardwareexit devices;2″diameter for use with Von Duprin exit devices— for rim and vertical rod exit devices, throughdoor; for mortise exit devices, from outside intomortise cavity— drill for EV function only■ lift finger slot— for Precision Hardware exit devices,11/8″diameter slot— for Von Duprin exit devices, 3/4″diameter slot— through doorNote 1: To locate the center of a hole on the oppositeside of the door, drill a pilot hole through the door.Note 2: For holes through the door, drill halfway fromeach side of the door to keep the door from splintering.2 For new installations, drill the exit hardware holesand mortise the inside surface of the door according tothe instructions provided by the exit hardwaremanufacturer.Note: The B.A.S.I.S. outside escutcheon is mounted usingthe four lock stile case mounting holes, labeled ‘A’ on theexit hardware template.