B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Servicing Standard Mortise Case PartsThe following table shows how the bolts, hubs, and cylinder clampplate should be oriented for the hand and bevel options. Theorientation indicated assumes that the case is on a flat surface, the casecover has been removed, and the part is in the case.Bolts Outside hub Inside hub Clamp plateLH bevel up top bottom screw upRH bevel down bottom top screw downLHRB bevel down top bottom screw upRHRB bevel up bottom top screw downChanging thehand onlyChanging thebevel onlyChanging thehand and bevelRefer to the detailed instructions for each task that follows.1. Remove and open the mortise case (page 6–2).2. Perform the steps in Turning over the hubs (page 6–6).3. If the lock has key override, perform the steps in Turning over thecylinder clamp plate (page 6–7).4. Perform the steps in Turning over the auxiliary bolt (page 6–8).5. Perform the steps in Turning over the latchbolt (page 6–9).6. Close and reinstall the mortise case (page 6–2).Refer to the detailed instructions for each task that follows.1. Remove and open the mortise case (page 6–2).2. Perform the steps in Turning over the auxiliary bolt (page 6–8).3. Perform the steps in Turning over the latchbolt (page 6–9).4. Close and reinstall the mortise case (page 6–2).Refer to the detailed instructions for each task that follows.1. Remove and open the mortise case (page 6–2).2. Perform the steps in Turning over the hubs (page 6–6).3. If the lock has key override, perform the steps in Turning over thecylinder clamp plate (page 6–7).4. Close and reinstall the mortise case (page 6–2).B.A.S.I.S. G Service Manual 6–5