B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Completing the installation20 Test lockTo test the lock for proper operation before the lock isprogrammed, use the temporary operator card that camewith the lock. This card is for temporary use only. Afterpermanent cards have been programmed for the lock, thetemporary card should be deleted.1 Use the temporary operator card to activate the lock.When the lock detects the presence of a card for thefirst time, the lock performs a series of diagnostic selftests.If no problem is detected, the lock responds with4 red LED flashes, simultaneous with 4 green LEDflashes and 4 short tones.If a problem is detected, the lock’s red LED andgreen LED simultaneously flash in a repeating pattern(and no tones sound). The lock’s control electronicsboard must be replaced. For instructions, see theB.A.S.I.S. G Service Manual (T63300) or the B.A.S.I.S. VService Manual (T61805).Note: If the lock has a proximity card reader, it may havealready been activated by the presence of an object nearthe card reader.2 Use the temporary operator card to access the lock.The green light flashes and the locking mechanismunlocks.3 Turn the lever and open the door.If the mechanism doesn’t unlock, refer to thefollowing table. For additional troubleshootinginstructions, see the B.A.S.I.S. G Service Manual or theB.A.S.I.S. V Service Manual.Installation Instructions for B.A.S.I.S. Mortise LocksFor all EV and FV function locksInsert and turn the key to unlatch the door.For all FV and LV function locksFrom the inside of the door, turn the turn knob andmake sure that the deadbolt operates properly.LEDs Sounder You shouldSingle — Use the card at a moderate speed.red flashRedflashesGreenflashes3 shorttonesUse the temporary operator cardprovided with the lock.— Check the motor connection.— — Check the battery connection.BEST ACCESS SYSTEMSIndianapolis, Indiana15