B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Installation Instructions for B.A.S.I.S. EX Series Exit Hardware TrimCompleting the installation19 Test lockTo test the lock for proper operation before the lock isprogrammed, use the temporary operator card that camewith the lock. This card is for temporary use only. Afterpermanent cards have been programmed for the lock, thetemporary card should be deleted.1 Use the temporary operator card to activate the lock.When the lock detects the presence of a card for thefirst time, the lock performs a series of diagnostic selftests.If no problem is detected, the lock responds with4 red LED flashes, simultaneous with 4 green LEDflashes and 4 short tones.If a problem is detected, the lock’s red LED andgreen LED simultaneously flash in a repeating pattern(and no tones sound). The lock’s control electronicsboard must be replaced. For instructions, see theB.A.S.I.S. G Service Manual (T63300) or the B.A.S.I.S. VService Manual (T61805).Note: If the lock has a proximity card reader, it may havealready been activated by the presence of an object nearthe card reader.2 Use the temporary operator card to access the lock.The green light flashes and the locking mechanismunlocks.3 Turn the lever and open the door.If the mechanism doesn’t unlock, refer to thefollowing table. For additional troubleshootinginstructions, see the B.A.S.I.S. G Service Manual or theB.A.S.I.S. V Service Manual.Important: When the trim and exit hardwareinstallation is complete, perform all testing specifiedby the exit hardware manufacturer.LEDs Sounder You shouldSinglered flash— Use the card at a moderate speed.Redflashes3 shorttonesUse the temporary operator cardprovided with the lock.— — Check the battery connection.For EV function locksInsert and turn the key to unlatch the door.© 2001–2002 Best Lock Corporation dba Best Access Systems.T61828/Rev A 1844200 ER-7991-12 July 200212BEST ACCESS SYSTEMSIndianapolis, Indiana