B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Installation Instructions for B.A.S.I.S. EX Series Exit Hardware TrimCompleting the installationFigure 11Com portNutBattery bracketInstalling the com port in the battery bracket14 Install strike(s)Note: If retrofitting the B.A.S.I.S. trim to an existing exithardware installation, skip this task.1 Install the strike(s) in the door frame or door stop;follow the instructions provided by the exit hardwaremanufacturer.2 Check the lock for proper alignment between thestrike(s) and latch(es).15 Install com port in battery bracket1 Routing the wire harness into the bottom of thebattery bracket, slide the com port into its mountingslot inside the battery bracket as shown in Figure 11.Note: The com port is used when programming thecontrol electronics for the lock.2 Tighten the nut to secure the com port to the bracket.BatterybracketMountingscrews16 Install battery bracket on door1 Position the battery bracket on the inside of the dooras shown in Figure 12.Note: If installing with a surface rod exit device, thebattery bracket is mounted over the upper rod.2 Secure the battery bracket to the door using two of themounting screws provided.Note: For doors less than 2″ in thickness, use the1 1/4″ screws. For doors 2″ or greater, use the1 3/4″ screws.Caution: When routing the wire harness, makesure the wires are not routed across any sharpedges or over any surface that could damage theirsleeving or wire insulation.Figure 12Inside of doorInstalling the battery bracket on the door10BEST ACCESS SYSTEMSIndianapolis, Indiana