B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Installing the lockInstallation Instructions for B.A.S.I.S. Mortise Locks13 Make motor and sensor connectionsFrom the inside of the door, make the motorconnection, the key override sensor connection (EVand FV functions) † , and the deadbolt sensorconnection (FV and LV functions).Note 1: It is physically possible to connect the keyoverride sensor connector from the mortise case to thebattery connector from the wire harness. To avoid thismistake, connect only the connectors with matching wirecolors.Note 2: The upgrade cable is used for reprogrammingthe lock’s firmware without removing the lock from thedoor. This cable does not connect to a mating lockconnector.Caution: When making the motor connection andsensor connections, make sure:■ there are no loose wire connections where thewires are inserted into the connectors■ the connectors are firmly mated.MotorconnectionInside of doorUpgrade cableDeadbolt sensorconnectionKey overridesensor connectionWire connectionColorsNo. ofwiresNo. ofpinsMotorYellow 2 2GrayKey override sensor Gray 2 3Deadbolt sensor Blue 2 3Figure 13Making the motor connection andsensor connections† Key override sensing is optional for 35HG andstandard for 35HBV.BEST ACCESS SYSTEMSIndianapolis, Indiana9