B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Servicing Standard Mortise Case PartsSERVICING THE MORTISE CASERemoving andopening the mortisecase1. Remove the inside and outside trim from the door. Instructionsbegin on page 5–1.2. From the edge of the door, remove the two case mounting screws.3. Remove the case from the door.Mortise cavityMortise caseBevel adjustingscrewCasemountingscrewsLocation of beveladjusting screwSensor & motorwire hole andwiresInside of doorClosing andreinstalling themortise caseFigure 6.1Removing and reinstalling the mortise case4. Set the case on a flat surface.5. Remove the case cover screw from the mortise case spacer. Removethe case spacer.6. Remove the remaining four case cover screws. Carefully remove thecase cover. Many parts are spring loaded and may shift.1. Route the motor and sensor wires through the openings in the case.2. Place the case cover on the case and install the four case coverscrews.3. Install the mortise case spacer and the case cover screw.4. Insert the mortise case into the mortise cavity, while feeding thesensor and motor wires into the mortise cavity and out the sensor &motor wire hole to the inside of the door.Note: If the armored front of the mortise case is not flush with thedoor edge, remove the case and loosen the screws at the top andbottom of the case. Adjust the bevel of the armored front of themortise case to match the bevel of the door. Tighten the screws andinsert the mortise case back into the mortise cavity.5. Secure the mortise case with the case mounting screws.6. Reinstall the inside and outside trim on the door. Instructions beginon page 5–1.6–2 B.A.S.I.S. G Service Manual