B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Preparing the doorInstallation Instructions for B.A.S.I.S. EX Series Exit Hardware Trim3 Position trim template and mark drillpoints1 For new installationsa Cut the G08 Template—Installation Template forEXG & EXBV Exit Hardware Trim for Use with PrecisionHardware 1000/2000 Series Locks or G07Template—Installation Template for EXG & EXBV ExitHardware Trim for Use with Von Duprin 98/99 SeriesLocks along the dashed lines.b Align the horizontal and vertical arrows marked onthe template with the centerlines marked on thedoor. See Figure 1.For retrofit installationsAlign the mounting holes for the escutcheon andlock stile case marked on the template with themounting holes in the door. See Figure 1.Note: The B.A.S.I.S. outside escutcheon is mountedusing the four lock stile case mounting holes(‘A’ holes); these holes must be 7/16″ in diameter anddrilled completely through the door.2 Tape the template to the door.3 Center punch the necessary drill points. Refer to theinstructions on the template.Figure 1Outside of doorVertical centerlineof lockTrim templateHorizontal centerlineof lockPositioning the B.A.S.I.S. trim template4 Mortise for mortise case and faceplate(mortise exit devices only)Note: If retrofitting the B.A.S.I.S. trim to an existing exithardware installation, skip this task.Mortise the edge of the door for the mortise case andfaceplate; follow the instructions provided by the exithardware manufacturer.BEST ACCESS SYSTEMSIndianapolis, Indiana3