B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Installation Instructions for B.A.S.I.S. Mortise LocksTurn knobholeSensor & motorwire holeInside of RH doorFigure 4aCylinder holeOutside of LHRB doorFigure 4b.125Outside of RHRB doorDrilling the RH and RHRB holes.125Inside of LH doorDrilling the LH and LHRB holesHarness holeUpper trimholeCylinder holeThrough-boltholesLever holeLower trimholeHarness holeUpper trimholeTurn knobholeThrough-boltholesLever holeLower trimholeSensor &motor wireholePreparing the door and door jamb4 Drill holesCaution: Check for the correct lock function, hand,and bevel before drilling.Drill the holes listed below:■ upper and lower trim holes—5/8″ diameter— through door■ harness hole—3/4″ diameter— through door— location based on handing■ cylinder hole—13/8″ diameter— from outside into mortise cavity— EV and FV functions only■ turn knob hole—5/8″ diameter— from inside into mortise cavity— FV and NV functions only■ upper and lower through-bolt holes—3/8″ diameter— through door■ lever hole—7/8″ diameter— through door■ sensor & motor wire hole—3/4″ diameter— from inside into mortise cavity, approximately1″ deepNote 1: To locate the center of a hole on the oppositeside of the door, drill a pilot hole completely through thedoor.Note 2: For holes through the door, it is best to drillhalfway from each side of the door to prevent the doorfrom splintering.4BEST ACCESS SYSTEMSIndianapolis, Indiana